Cisco ONS 15454 Series User Manual

Figures
xxiii
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Figure 20-3 Manually Routing a VCAT Circuit 20-15
Figure 20-4 Port Status on the LCD Panel 20-31
Figure 20-5 Signal Type Drop-Down Lists for a DS3XM-6 Card 20-35
Figure 20-6 FC_MR-4 Statistics on the Card View Performance Window 20-37
Figure 20-7 FC_MR-4 Utilization on the Card View Performance Window 20-38
Figure 20-8 FC_MR-4 History on the Card View Performance Window 20-39
Figure 20-9 Manually Routing an OC-N Circuit 20-54
Figure 20-10 Manually Routing a BLSR-DRI Circuit Route 20-55
Figure 20-11 MiniBNC EIA Screw Locations 20-58
Figure 20-12 MiniBNC EIA Jack Screw 20-58
Figure 20-13 Installing the MiniBNC EIA 20-59
Figure 20-14 UBIC-V Slot Designations 20-71
Figure 20-15 Fully Cabled UBIC-V; Front and Side View 20-72
Figure 20-16 Partially Cabled UBIC-V 20-73
Figure 20-17 CTC Node View 20-85
Figure 20-18 Ether Ports Statistics on the CE-Series Card View Performance Window 20-87
Figure 20-19 Ether Ports Utilization on the CE-Series Card View Performance Window 20-89
Figure 20-20 Ether Ports History on the CE-Series Card View Performance Window 20-90
Figure 20-21 Viewing DS3XM-12 Card DSn/SONET Performance Monitoring Information 20-92
Figure 20-22 Viewing DS3XM-12 Card BFDL Performance Monitoring Information 20-93
Figure 20-23 Installed Alignment Standoffs 20-98
Figure 20-24 UBIC-H Alignment Pins 20-99
Figure 20-25 UBIC-H EIA Screw Locations 20-100
Figure 20-26 UBIC-H EIA Jack Screw 20-100
Figure 20-27 Installing the UBIC-H EIA 20-101
Figure 21-1 Fully Cabled UBIC-H (A-Side) 21-22
Figure 21-2 Verifying Pass-Through STSs 21-23
Figure 22-1 Viewing OC-N Card Performance Monitoring Information 22-2
Figure 22-2 Selecting CTC Data For Print 22-6
Figure 22-3 Selecting CTC Data For Export 22-7
Figure 22-4 Store Profiles Dialog Box 22-12
Figure 22-5 E-Series Card Alarm Profile 22-13
Figure 22-6 Select Node/Profile Combination For Delete Dialog Box 22-15
Figure 22-7 Alarm Filter Dialog Box General Tab 22-16
Figure 22-8 Alarm Filter Dialog Box Conditions Tab 22-17

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform