Cisco ONS 15454 Series User Manual

Figures
xxii
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Figure 17-21 Connecting Fiber to an Eight-Node Traditional Path Protection Dual-Ring Interconnect 17-51
Figure 17-22 Connecting Fiber to a Six-Node Integrated Path Protection Dual-Ring Interconnect 17-52
Figure 17-23 Connecting Fiber to a Four-Node, Two-Fiber BLSR 17-53
Figure 17-24 Connecting Fiber to a Four-Node, Four-Fiber BLSR 17-54
Figure 17-25 Attaching a Fiber Boot 17-55
Figure 17-26 Logging into CTC 17-68
Figure 17-27 Login Node Group 17-70
Figure 17-28 Selecting the IP Address Option 17-71
Figure 17-29 Changing the IP Address 17-72
Figure 17-30 Selecting the Save Configuration Option 17-72
Figure 17-31 Saving and Rebooting the TCC2/TCC2P 17-72
Figure 17-32 Creating a 1:1 Protection Group 17-79
Figure 17-33 Creating a 1:N Protection Group 17-80
Figure 17-34 Creating a 1+1 Protection Group 17-82
Figure 18-1 CTC Preferences Dialog Box 18-2
Figure 18-2 Node View Conditions Window 18-4
Figure 18-3 Node View Alarm Behavior Window 18-6
Figure 18-4 Enabling or Disabling Pointer Justification Count Parameters 18-8
Figure 18-5 SONET STS Tab for Enabling or Disabling IPPM 18-10
Figure 18-6 Installed Alignment Standoffs 18-62
Figure 18-7 UBIC-V Alignment Pins 18-63
Figure 18-8 UBIC-V EIA Screw Locations 18-64
Figure 18-9 UBIC-V EIA Jack Screw 18-64
Figure 18-10 Installing the UBIC-V EIA 18-65
Figure 18-11 Circuits on Span Dialog Box with a Force Switch 18-69
Figure 19-1 Installing Fiber-Optic Cables 19-6
Figure 19-2 Protection Operation on a Three-Node BLSR 19-11
Figure 19-3 Reinitialization Tool 19-26
Figure 19-4 G-Series Statistics on the Card View Performance Window 19-39
Figure 19-5 G-Series Utilization on the Card View Performance Window 19-40
Figure 19-6 Ethernet History on the Card View Performance Window 19-41
Figure 19-7 Selecting the Edit Path Trace Option 19-48
Figure 19-8 Protection Operation on a Three-Node BLSR 19-64
Figure 20-1 Ether Ports on the ML-Series Card View Performance Window 20-11
Figure 20-2 POS Ports on the ML-Series Card View Performance Window 20-12

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform