Cisco ONS 15454 Series - Page 36

Tasks
xxxvi
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
DLP-A33 Measure Voltage 17-39
DLP-A34 Create an Optimized 1+1 Protection Group 17-40
DLP-A35 Modify an Optimized 1+1 Protection Group 17-41
DLP-A36 Install the TCC2/TCC2P Cards 17-42
DLP-A37 Install the XCVT or XC10G Cards 17-45
DLP-A38 Install the Alarm Interface Controller or Alarm Interface Controller–International Card 17-47
DLP-A39 Install Ethernet Cards 17-48
DLP-A43 Install Fiber-Optic Cables for Path Protection Configurations 17-49
DLP-A44 Install Fiber-Optic Cables for BLSR Configurations 17-52
DLP-A45 Install the Fiber Boot 17-54
DLP-A50 Set Up a Windows PC for Craft Connection to an ONS 15454 on the Same Subnet Using Static IP
Addresses
17-56
DLP-A51 Set Up a Windows PC for Craft Connection to an ONS 15454 Using Dynamic Host Configuration
Protocol
17-58
DLP-A52 Set Up a Windows PC for Craft Connection to an ONS 15454 Using Automatic Host Detection 17-61
DLP-A53 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454 17-63
DLP-A56 Disable Proxy Service Using Internet Explorer (Windows) 17-65
DLP-A57 Disable Proxy Service Using Netscape (Windows and UNIX) 17-66
DLP-A60 Log into CTC 17-66
DLP-A61 Create Login Node Groups 17-69
DLP-A62 Add a Node to the Current Session or Login Group 17-70
DLP-A64 Set the IP Address, Default Router, and Network Mask Using the LCD 17-71
DLP-A65 Create a Static Route 17-73
DLP-A67 Provision the IIOP Listener Port on the ONS 15454 17-74
DLP-A68 Provision the IIOP Listener Port on the CTC Computer 17-74
DLP-A69 Set Up External or Line Timing 17-75
DLP-A70 Set Up Internal Timing 17-77
DLP-A71 Create a 1:1 Protection Group 17-78
DLP-A72 Create a 1:N Protection Group 17-80
DLP-A73 Create a 1+1 Protection Group 17-81
DLP-A74 Create a New User on a Single Node 17-82
DLP-A75 Create a New User on Multiple Nodes 17-83
DLP-A83 Provision Orderwire 17-84
DLP-A88 Optical 1+1 Protection Test 17-85
DLP-A89 Remap the K3 Byte 17-87
DLP-A91 BLSR Switch Test 17-87