Contents
iv
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
NTP- A10 Route Electrical Cables 1-22
NTP- A11 Install the Rear Cover 1-22
NTP- A12 Install Ferrites 1-29
NTP- A13 Perform the Shelf Installation Acceptance Test 1-30
CHAPTER
2 Install Cards and Fiber-Optic Cable 2-1
Before You Begin 2-1
NTP- A15 Install the Common Control Cards 2-2
NTP- A16 Install the OC-N Cards 2-6
NTP- A17 Install the Electrical Cards 2-8
NTP- A246 Install Ethernet Cards and Connectors 2-10
NTP- A274 Install the FC_MR-4 Cards 2-11
NTP- A316 Install the Filler Cards 2-13
NTP- A247 Install Fiber-Optic Cables on OC-N Cards 2-14
NTP- A245 Route Fiber-Optic Cables 2-17
NTP- A116 Remove and Replace a Card 2-17
NTP- A20 Replace the Front Door 2-18
CHAPTER
3 Connect the PC and Log into the GUI 3-1
Before You Begin 3-1
NTP- A260 Set Up Computer for CTC 3-1
NTP- A234 Set Up CTC Computer for Local Craft Connection to the ONS 15454 3-2
NTP- A235 Set Up a CTC Computer for a Corporate LAN Connection to the ONS 15454 3-4
NTP- A236 Set Up a Remote Access Connection to the ONS 15454 3-5
NTP- A23 Log into the ONS 15454 GUI 3-6
CHAPTER
4 Turn Up Node 4-1
Before You Begin 4-1
NTP- A24 Verify Card Installation 4-2
NTP- A30 Create Users and Assign Security 4-4
NTP- A25 Set Up Name, Date, Time, and Contact Information 4-4
NTP- A261 Set Power Monitor Thresholds 4-6
NTP- A169 Set Up CTC Network Access 4-7
NTP- A27 Set Up the ONS 15454 for Firewall Access 4-8
NTP- A28 Set Up Timing 4-9
NTP- A170 Create Protection Groups 4-10
To Next Page
Loading...
