Cisco ONS 15454 Series - Page 5

Contents
v
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
NTP- A256 Set Up SNMP 4-12
CHAPTER 5 Turn Up Network 5-1
Before You Begin 5-1
NTP- A35 Verify Node Turn-Up 5-2
NTP- A124 Provision a Point-to-Point Network 5-3
NTP- A173 Point-to-Point Network Acceptance Test 5-4
NTP- A38 Provision a Linear ADM Network 5-6
NTP- A174 Linear ADM Network Acceptance Test 5-8
NTP- A40 Provision BLSR Nodes 5-10
NTP- A126 Create a BLSR 5-12
NTP- A175 Two-Fiber BLSR Acceptance Test 5-13
NTP- A176 Four-Fiber BLSR Acceptance Test 5-15
NTP- A178 Provision a Traditional BLSR Dual-Ring Interconnect 5-17
NTP- A179 Provision an Integrated BLSR Dual-Ring Interconnect 5-19
NTP- A44 Provision Path Protection Nodes 5-20
NTP- A177 Path Protection Acceptance Test 5-22
NTP- A216 Provision a Traditional Path Protection Dual-Ring Interconnect 5-24
NTP- A217 Provision an Integrated Path Protection Dual-Ring Interconnect 5-26
NTP- A180 Provision a Traditional BLSR/Path Protection Dual-Ring Interconnect 5-27
NTP- A209 Provision an Integrated BLSR/Path Protection Dual-Ring Interconnect 5-30
NTP- A224 Provision an Open-Ended Path Protection 5-31
NTP- A225 Open-Ended Path Protection Acceptance Test 5-33
NTP- A46 Subtend a Path Protection from a BLSR 5-36
NTP- A47 Subtend a BLSR from a Path Protection 5-37
NTP- A48 Subtend a BLSR from a BLSR 5-38
NTP- A172 Create a Logical Network Map 5-40
CHAPTER 6 Create Circuits and VT Tunnels 6-1
Before You Begin 6-1
NTP- A127 Verify Network Turn Up 6-4
NTP- A181 Create an Automatically Routed DS-1 Circuit 6-6
NTP- A182 Create a Manually Routed DS-1 Circuit 6-11
NTP- A183 Create a Unidirectional DS-1 Circuit with Multiple Drops 6-14
NTP- A184 Create an Automatically Routed DS-3 Circuit 6-18
NTP- A185 Create a Manually Routed DS-3 Circuit 6-23