Cisco ONS 15454 Series User Manual

Contents
vi
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
NTP- A186 Create a Unidirectional DS-3 Circuit with Multiple Drops 6-25
NTP- A133 Create an Automatically Routed VT Tunnel 6-29
NTP- A134 Create a Manually Routed VT Tunnel 6-31
NTP- A187 Create a VT Aggregation Point 6-33
NTP- A135 Test Electrical Circuits 6-36
NTP- A257 Create an Automatically Routed OC-N Circuit 6-38
NTP- A295 Create a Manually Routed OC-N Circuit 6-43
NTP- A314 Create a Unidirectional OC-N Circuit with Multiple Drops 6-46
NTP- A62 Test OC-N Circuits 6-51
NTP- A139 Create a Half Circuit on a BLSR or 1+1 Node 6-52
NTP- A140 Create a Half Circuit on a Path Protection Node 6-54
NTP- A191 Create an E-Series EtherSwitch Circuit (Multicard or Single-Card Mode) 6-56
NTP- A192 Create a Circuit for an E-Series Card in Port-Mapped Mode 6-59
NTP- A142 Create an E-Series Shared Packet Ring Ethernet Circuit 6-61
NTP- A143 Create an E-Series Hub-and-Spoke Ethernet Configuration 6-64
NTP- A144 Create an E-Series Single-Card EtherSwitch Manual Cross-Connect 6-66
NTP- A145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect 6-69
NTP- A146 Test E-Series Circuits 6-72
NTP- A147 Create a G-Series STS Circuit 6-73
NTP- A148 Create a Manual Cross-Connect for a G-Series or E-Series Card in Port-Mapped Mode 6-76
NTP- A241 Provision G-Series Ports for Transponder Mode (Tx Mode) 6-78
NTP- A149 Test G-Series Circuits 6-81
NTP- A304 Provision CE-100T-8 Ethernet Ports 6-82
NTP- A305 Provision CE-100T-8 POS Ports 6-84
NTP- A194 Create Overhead Circuits 6-85
NTP- A264 Create an Automatically Routed VCAT Circuit 6-86
NTP- A265 Create a Manually Routed VCAT Circuit 6-90
NTP- A167 Create an STS Test Circuit around the Ring 6-93
CHAPTER 7 Manage Alarms 7-1
Before You Begin 7-1
NTP- A195 Document Card, Node, and Network Provisioning 7-2
NTP- A196 View Alarms, History, Events, and Conditions 7-2
NTP- A68 Delete Cleared Alarms from Display 7-3
NTP- A69 View Alarm-Affected Circuits 7-4
NTP- A70 View Alarm Counts on the LCD for a Node, Slot, or Port 7-6

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform