Cisco ONS 15454 Series User Manual

6-72
Cisco ONS 15454 Procedure Guide, R5.0
August 2005
Chapter 6 Create Circuits and VT Tunnels
NTP-A146 Test E-Series Circuits
NTP-A146 Test E-Series Circuits
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66 at the ONS 15454 source Ethernet node.
Step 2 On the shelf graphic, double-click the circuit source card.
Step 3 Click the Provisioning > Ether Port tabs.
Step 4 Verify the following settings:
• Mode—Auto, 10 Half, 10 Full, 100 Half, or 100 Full.
• Enabled—Checked.
• Priority—Set to the priority level indicated by the circuit or site plan. Priority does not apply to
E-Series cards in port-mapped mode.
• Stp State—Checked if Spanning Tree Protocol is enabled for the circuit. Stp does not apply to
E-Series cards in port-mapped mode.
Step 5 Click the Ether VLAN tab. If the E-Series cards is not in port-mapped mode, verify that the source port
is on the same VLAN as the destination port.
Step 6 Repeat Steps 1 through 5 for the destination node.
Step 7 At the destination node, connect the Ethernet test set to the destination port and configure the test set to
send and receive the appropriate Ethernet traffic.
Note At this point, you are not able to send and receive Ethernet traffic.
Purpose This procedure tests circuits created on E-Series Ethernet cards
provisioned for multicard EtherSwitch, single-card EtherSwitch, or
port-mapped mode.
Tools/Equipment Ethernet test set and appropriate fibers
Prerequisite Procedures This procedure assumes you completed facility loopback tests to test the
fibers and cables from the source and destination ONS 15454s to the fiber
distribution panel or the DSX, and one of the following procedures:
NTP-A191 Create an E-Series EtherSwitch Circuit (Multicard or
Single-Card Mode), page 6-56
NTP-A192 Create a Circuit for an E-Series Card in Port-Mapped Mode,
page 6-59
NTP-A142 Create an E-Series Shared Packet Ring Ethernet Circuit, page
6-61
NTP-A143 Create an E-Series Hub-and-Spoke Ethernet Configuration,
page 6-64
NTP-A145 Create an E-Series Multicard EtherSwitch Manual
Cross-Connect, page 6-69
Required/As Needed As needed
Onsite/Remote Onsite
Security Provisioning or higher

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform