Cisco ONS 15454 Series - Page 833

Index
IN-5
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
view information 21-2
Cisco Transport Controller see CTC
CLEI code
A-13
clock
change time
18-16
reset 17-19
set time 4-5
coaxial cable
attenuation rate
17-35
BNC connectors 17-32
high-density BNC connectors 17-33
route 17-35
SMB connectors 17-33
tie-down bar 22-27
common control cards see TCC2 card, TCC2P card, XCVT
card, or XC10G card
computer see PC
conditions
check network for conditions
19-63
modify filtering parameters 22-16
view at card, node, or network level 18-4
configurations see networks
CORBA see IIOP
corporate LAN
3-4
cost 17-73, 18-17, 19-34
counts see performance monitoring
covers
rear (plastic) cover
1-22
remove lower backplane cover 17-10
remove the backplane sheet metal cover 17-11
craft connection 3-2
crimp tool 1-4, 17-20
cross-connect (circuit)
see also circuits
definition
6-66
E series multicard EtherSwitch 6-69
E series single-card EtherSwitch 6-66
G-Series 6-76
cross-connect cards
see XC10G card
see XCVT card
CTC
see also PC setup
20-24
toolbar icons see toolbar icons
alerts
20-16
back up the database 15-4
card protection setup 4-10
connect PCs 3-2, 3-4
export data 22-6
firewall access 4-8
installation wizard (UNIX) 20-27
installation wizard (Windows) 20-24
log in 3-6
login node groups 17-69
node setup 4-4
PC requirements 20-24
print data 22-5
remote site access 3-5
saving alert text 20-22
set up network access 4-7
timing setup 4-9, 10-5
UNIX workstation requirements 20-27
verify software release 17-44
views see views
D
database
back up
15-4
clear during disaster recovery 15-8, 19-25, 19-27
parameters that are not restored 15-9
restore node and card defaults during disaster
recovery
15-8
restore the database 15-5
data communications channel see DCC
date
change setting
18-16
default 17-19