Contents
ix
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
NTP- A159 Modify a BLSR 13-18
CHAPTER
14 Add and Remove Nodes 14-1
Before You Begin 14-1
NTP- A212 Add a BLSR Node 14-2
NTP- A240 Remove a BLSR Node 14-6
NTP- A105 Add a Path Protection Node 14-9
NTP- A294 Remove a Path Protection Node 14-11
NTP- A262 Add a Node to a Linear ADM 14-13
NTP- A312 Add a Node to a Linear ADM Using the Wizard 14-14
NTP- A313 Remove an In-Service Node from a Linear ADM 14-17
CHAPTER
15 Maintain the Node 15-1
Before You Begin 15-1
NTP- A107 Inspect, Clean, and Replace the Air Filter 15-2
NTP- A108 Back Up the Database 15-4
NTP- A109 Restore the Database 15-5
NTP- A163 Restore the Node to Factory Configuration 15-8
NTP- A300 Viewing the Audit Trail Records 15-9
NTP- A214 Off-Load the Audit Trail Record 15-11
NTP- A306 Off-Load the Diagnostics File 15-12
NTP- A302 Initiate or Clear an External Switching Command 15-12
NTP- A112 Clean Fiber Connectors 15-13
NTP- A113 Reset the TCC2/TCC2P Using CTC 15-14
NTP- A311 Hard-Reset a CE-100T-8 Card Using CTC 15-15
NTP- A310 Soft-Reset a CE100T-8 Card Using CTC 15-16
NTP- A215 View G-Series Ethernet Maintenance Information 15-16
NTP- A239 View E-Series Ethernet Maintenance Information 15-17
NTP- A218 Change the Node Timing Reference 15-18
NTP- A223 View the ONS 15454 Timing Report 15-18
NTP- A287 Replace an In-Service Cross-Connect Card 15-21
NTP- A288 Replace the Fan-Tray Assembly 15-22
NTP- A290 Replace the Alarm Interface Panel 15-26
NTP- A291 Replace the Plastic Lower Backplane Cover 15-31
NTP- A162 Replace the UBIC-V EIA 15-33
NTP- A266 Edit Network Element Defaults 15-35
To Next Page
Loading...
Need help?
General
