Cisco ONS 15454 Series User Manual

Contents
viii
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
NTP- A205 Modify Users and Change Security 10-6
NTP- A87 Change SNMP Settings 10-6
CHAPTER 11 Change Card Settings 11-1
Before You Begin 11-1
NTP- A88 Modify Line Settings and PM Parameter Thresholds for Electrical Cards 11-2
NTP- A89 Modify Line Settings and PM Parameter Thresholds for OC-N Cards 11-2
NTP- A90 Modify Alarm Interface Controller Settings 11-3
NTP- A118 Modify Alarm Interface Controller-International Settings 11-4
NTP- A91 Upgrade DS-1 and DS-3 Protect Cards from 1:1 Protection to 1:N Protection 11-4
NTP- A315 Modify Port Settings and PM Parameter Thresholds for FC_MR-4 Cards 11-5
NTP- A297 Change Card Service State 11-6
CHAPTER 12 Upgrade Cards and Spans 12-1
Before You Begin 12-1
NTP- A220 Upgrade the XCVT Card to the XC10G Card 12-2
NTP- A296 Upgrade the TCC2 Card to the TCC2P Card 12-3
NTP- A93 Upgrade the DS3-12 Card to the DS3-12E Card 12-5
NTP- A308 Upgrade In-Service Low-Density Electrical Cards to High-Density Electrical Cards 12-7
NTP- A254 Downgrade a DS3-12E/DS3NE Card to a DS3-12/DS3N-12 Card 12-10
NTP- A153 Upgrade the AIC Card to AIC-I 12-12
NTP- A94 Upgrade OC-N Cards and Spans Automatically 12-12
NTP- A95 Upgrade OC-N Spans Manually 12-15
CHAPTER 13 Convert Network Configurations 13-1
Before You Begin 13-1
NTP- A309 Convert a 1+1 Point-to-Point to a Linear ADM Automatically 13-2
NTP- A154 Convert a 1+1 Point-to-Point to a Linear ADM Manually 13-5
NTP- A303 Convert an Unprotected Point-to-Point or 1+1 Linear ADM to a Two-Fiber BLSR
Automatically
13-6
NTP- A155 Convert a 1+1 Point-to-Point or a Linear ADM to a Two-Fiber BLSR Manually 13-8
NTP- A299 Convert a Point-to-Point or Linear ADM to a Path Protection Automatically 13-11
NTP- A156 Convert a Point-to-Point or Linear ADM to a Path Protection Manually 13-12
NTP- A267 Convert a Path Protection to a Two-Fiber BLSR Automatically 13-13
NTP- A210 Convert a Path Protection to a Two-Fiber BLSR Manually 13-15
NTP- A211 Convert a Two-Fiber BLSR to a Four-Fiber BLSR Automatically 13-17

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform