Cisco ONS 15454 Series - Page 838

Index
IN-10
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
flow control watermark 21-7
foreign node setting
enable or disable using LDCC
20-60
enable or disable using SDCC 20-60
enable using LDCC 20-62
enable using SDCC 20-61
frame-ground pin 17-27
framing 17-77, 18-24
front door
open
17-8
remove 15-3, 17-9
replace 2-18
fuse and alarm panel
100 amp
1-10, 17-5, 17-6, 17-7, 17-22
80 amp 1-10, 17-5, 17-6, 17-7, 17-21
measure and cut cables 17-19
G
gateway network element 19-32
gateway settings 19-32, 19-52
GBICs
install
21-24
remove 21-26
route fiber 2-17
gigabit interface converter see GBIC
ground
1-9, 17-18
ground cable 1-3
ground strap 2-19, 17-10
G-Series Ethernet cards
compatible GBICs
21-25
create an STS circuit 6-73
flow control watermarks 21-7
install 2-10
path trace capability 19-47
provision ports 19-16
provison ports for transponder mode 6-78
refresh PM counts 20-33
route fiber 2-17
slot compatibility with XC10G cards 2-5
slot compatibility with XCVT cards 2-3
view history PMs 19-41
view maintenance information 15-16
view statistics 19-38
view utilization parameters 19-40
H
half circuits
create a half circuit on a BLSR or 1+1
6-52
create a half circuit on a path protection 6-54
provision a half circuit on a BLSR or 1+1 20-5
provision a half circuit on a path protection 20-6
hardware redundancy test 20-40
high-density BNC EIA
attach coaxial cable
17-33
install 17-12
high-density shelf
fuse panel requirement
17-5, 17-6, 17-7
high-density card requirement 1-4
install an AEP 1-12
UBIC-V EIAs 18-61
upgrade low-density electrical card protection to
high-density
12-7, 22-34, 22-37
upgrade low-density electrical cards to high-density
electrical cards
12-7
XC10G card requirement 2-4
hop 17-73, 18-17
hub-and-spoke 6-64
hybrid node icon A-3
I
idle time 17-83, 17-84
IIOP
change listener port
19-52
provision listener port on CTC 17-74
provision listener port on node 17-74