Page 6-197
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Phantom Devices
PROGRAMMING
6
Flags
4.175 You can enable a flag by selecting the current value and then selecting the check box to
place a check in it. Some flags require you to choose between two settings (such as Hunt
Group Remove/Replace). For those flags, select the current value and use the scroll box to
select the desired value. Press
ENTER or select another field to save your changes. The phan-
tom flags that can be programmed include:
• Alternate Hold Timer
• Attendant
• DID/E&M Receive Busy Instead of Camp-On
• Do-Not-Disturb Allowed
• Hunt Group Remove/Replace
• Manual Forward to Public Network
• Receive Busy Instead of DND
• System Forwarding
Forwarding Paths
4.176 When created, phantoms are automatically added to the All Stations (PP051) extension
list. Phantoms can be forwarded and follow the rules for station manual and system forward-
ing. The forwarding displays and rules are the same as in previous versions.
Mailboxes
4.177 If the phantom being programmed serves as the message notification station for one or
more mailboxes, the mailbox(es) will appear in the Mailboxes list. Select Mailboxes to see the
list of mailboxes assigned to this phantom. You cannot program the mailbox here, but if you
double-click on the mailbox, the screen will jump to the Mailbox programming area.
Password
4.178 This password is used for the Remote Programming feature. The Phantom password
can be up to eight digits in length. The default password is the extension number of the Phan-
tom. The password can also be changed by entering the Program Endpoint Password feature
code at the endpoint or when using the Remote Programming feature.
Audio for Calls Camped onto this Device
4.179 The Audio for Calls Camped onto this Device field defines the audio that a caller hears
when camped-on to this node trunk or IP connection group. To program this field, use the
drop-down list to select the type of audio and press
ENTER. Your options are Silence, Tick-
tone, Ringback, or Board. If you select
Board, specify the music source in the Extended Value
field. The default is Board, and the default extended value is 01:08 Central Processor.
Audio for Calls Holding for this Device
4.180 This field defines the audio that a caller hears when holding for the device. The default
is Board. Other options include Silence, Tick Tone, and Ringback.
Audio for Calls Ringing this Device
4.181 This field defines the audio that a caller hears when ringing the device. The default is
Ringback. Other options include Silence, Tick Tone, and Board.
To Next Page
Loading...
