Page 6-109
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Review and Update for Enabling a Voice Processor
PROGRAMMING
6
7. Restart a local DB Programming session.
8. After the voice processor is enabled, it can be configured and programmed in accor-
dance with customer requirements. See the following graphic showing a sample of the
Voice Processor folder contents.
9. From the DB Studio menu bar, select Operations – Database Operations – Database
Save
. Identify the location where you want to store the system database, then check the
Save Voice Data to: box and identify the location where you want to save the voice
processor database.
10. Click Start. System and voice processor databases are saved to the locations indicated.
Review and Update for Enabling a Voice Processor
2.11 Inter-Tel Axxess platforms support any of the following voice processors: Enterprise
Messaging (EM), an Embedded Voice Mail Card (EVMC), or a Voice Processing Unit (VPU).
And, for proper configuration, DB Programming requires that the voice processor type is iden-
tified. After the VP is physically connected, the system senses which type it is.
2.12 As with previous versions, a voice processor connected to an Inter-Tel Axxess platform
auto-enables when the system boots up. To avoid the risk of overwriting an established data-
base with default values, Inter-Tel recommends connecting the voice processor first, then con-
necting with a remote mode session of DB Programming, and then saving.
2.13 To save a voice processor database in remote mode:
1. Connect the voice processing unit equipment to the system in accordance with Inter-Tel
installation instructions. See the applicable installation manual.
2. In remote mode, launch Session Manager and start a DB Programming session.
To Next Page
Loading...
