Inter-Tel AXXESS - Trunks

Page 6-244
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Trunks
R. TRUNKS
4.340 When “Trunks” is selected, the right side of the screen will show all trunks on the local
node. (T1 or E1 trunks with a switch type of “Private Networking” will appear in the trunk list,
but their programming fields cannot be changed.)
4.341 At this level, you can see the type of trunk and its circuit number (address). You can
perform the following options by right-clicking the extension of the desired trunk:
• Change Extension (see page 6-245)
• Batch Extension Change (see page 6-245)
• Copy a Trunk (see page 6-245)
• Assign CO Trunk Groups (see page 6-245)
• Run a Hybrid Balance Test (see page 6-246)
4.342 To program a specific trunk, double-click on the desired trunk. The following infor-
mation can be programmed:
• CO Trunk Group (see page 6-251)
• Call Configuration—MGCP gateways and endpoints and SIP trunks only (see page 6-
252)
• Network Group—MGCP gateways and endpoints and SIP trunks only (see page 6-252)
• SIP Gateway—SIP trunks only (see page 6-252)
• CP History—SIP trunks only (see page 6-252)
• MGCP Gateway IP Address—MGCP gateways only (see page 6-252)
• MGCP Gateway Port—MGCP gateways only (see page 6-252)
• Communication Timeout—MGCP gateways only (see page 6-253)
• Gateway Name—MGCP gateways only (see page 6-253)
• Associated Gateway—MGCP endpoints only (see page 6-253)
• Endpoint Name—MGCP gateways and endpoints only (see page 6-253)
• Service Type (see page 6-253)
• DTMF Signaling In Band (see page 6-254)
• Answer Supervision (see page 6-255)
• Connect Trunk-to-Trunk Call on Polarity Reversal (see page 6-255)
• Hybrid Balance (see page 6-256)
• Measured Echo Return Loss—ERL (see
page 6-256)
• Last Hybrid Balance Test Timestamp (see page 6-256)
• Service Base Number (see page 6-256)
• Language (see page 6-257)
• Transmit Gain (see page 6-257)
• Receive Gain (see page 6-257)
• Send Digits En Bloc—loop start and MGCP trunks only (see page 6-257)