Inter-Tel AXXESS - Node Programming Procedures; Node Trunk Lists; Off-Node Devices

Page A-23
Appendix A — Networking
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Node Programming Procedures
APPENDICES
B. NODE PROGRAMMING PROCEDURES
6.17 Programming a node involves several steps. You should program the network in the fol-
lowing order:
1. Local Node Number
2. Nodes
3. T1/PRI or T1/E1/PRI Cards
4. Node Trunk Groups
5. Node Trunk Lists
6. Off-Node Devices
Local Node Number
6.18 To program a node’s local node number and description:
1. Make sure the software license supports the required premium features, including
Advanced CO Interfaces and Automatic Route Selection.
NOTE: System versions prior to 7.0 require the appropriate number of premium fea-
ture units.
2.
In System\Devices and Feature Codes\Nodes, program the local node number and the
local node description. This causes the system to reset, and you will have to re-establish
the DB Programming connection.
Nodes
6.19 To program each of the nodes:
1. In System\Devices and Feature Codes\Nodes, create the Node.
2. Set the remote node number to the destination node.
3. Name the node (for example To Node X).
4. Repeat for all nodes.