Page 6-60
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Clear Filter, Save Filter, and Load Filter Command Buttons
Clear Filter, Save Filter, and Load Filter Command Buttons
10.43 There are three command buttons below the Specify A Filter box. They are used as fol-
lows:
• Clear Filter: You can remove the entire filter specification by selecting
Clear Filter.
This will remove the entire entry in the Specify A Filter box.
• Save Filter: There will probably be instances where you have a complex, or a com-
monly-used search that you will want to use over again. When you have a search state-
ment that you want to keep for future use, you can save it to floppy or hard disk for
later retrieval. The way to do this is to select
Save Filter when the search statement is in
the Specify A Filter box. A dialog box will appear asking you to specify a location and
file name. The PC will then save the file in that location with an extension of “FLT.”
• Load Filter: When you want to recall a saved search, select
Load Filter. A dialog box
will allow you to find your previously saved search string and restore it to the Specify
A Filter box.
[extension] LIKE “12*” AND [username]
LIKE “F*”
Extensions beginning with the digits 1 and 2 that
have usernames beginning with the letter F
[extension] < “1234” AND [username] =
“FRED”
Extensions with a number lower than 1234 that
also have a username of FRED
[slot_number] = 1 AND [extension] >=
“1000”
Stations on board number 1 having extension
numbers 1000 and higher
Table 6-12: SQL Command Combination Examples (Continued)
SQL Statement Search Result
To Next Page
Loading...
