Page C-5
Appendix C — CP Server
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
System Capacities
APPENDICES
3. SYSTEM CAPACITIES
3.1 The following table defines the capacities available when using a CP Server.
* This value is based on an eight-chassis ATM System. If using the CP Server with a non-ATM sys-
tem, the maximum number of devices is 1024.
** The maximum number of call routing table patterns depends on the number of digits that are trans-
lated (i.e., received from the CO). For example, if receiving ten digits, the maximum is approxi-
mately 2380 patterns; if receiving four digits, the maximum is approximately 2767.
NOTE: Even though a non-ATM database supports 1024 devices, the equipment chassis can-
not. Therefore, the number of devices is only limited by the hardware configuration in the Data-
base (DB) Programming.
Table C-1. CP Server System Capacities
Devices 1792*
Forced and Standard Account Codes 5000
Hunt Groups 300
Page Zones 50 (9600-9649)
System Speed Dial Numbers 5000 (0-4999)
ACD Agent IDs 3000
ARS Route Groups 100
Number of Facility Groups in a Route Group 100
Off-Node Devices 25,000
Call Routing Table Patterns 2000+**
Extension List Capacity 40,000 devices
Maximum Page Zone Recommendation 120 phones
Maximum All-Ring Hunt Group Recommendation 60 stations
Networking Internet Protocol Resource Cards (IPRCs or IPRC-Ds) 28
To Next Page
Loading...
