Inter-Tel AXXESS - Access to the Features

Page 5-13
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Access to the Features
FEATURES
5
4. ACCESS TO THE FEATURES
A. FEATURE CODES
4.1 Each of the station features is assigned a feature code. Using the station’s keypad, these
codes are entered to select trunks, process calls, and use special features. Complete explana-
tions of the features and instructions for using them begin on the next page.
4.2 The codes shown on the following pages are the values that are assigned when the sys-
tem is in the default state. If desired, they can be changed in DB Programming to any one- to
five-digit value.
B. FEATURE BUTTONS
4.3 Phones have feature buttons that allow one-button dialing of feature codes. Information
is programmed in the database to determine the arrangement of the feature buttons and their
default values. If desired, some of the phone feature buttons can be designated as user-pro-
grammable buttons. See page 5-132 for more information.
C. SPECIAL BUTTON AND HOOKFLASH [RECALL IN EUROPE]
4.4 Depending on the feature and system programming, users can either enter feature codes
immediately after lifting the handset or while on hook, or they must signal the system before
entering the feature code. Phone users signal the system by pressing the Special button (which
is represented by or
on the phone). Single-line DTMF set users perform a
hookflash (press and release the hookswitch quickly, or press
RECALL) or a recall (press
RECALL). If the user does not enter a code or begin dialing before the Dial Initiation timer
expires, the system sends reorder tones.
4.5 There is a system-wide option called “SPCL Key Required For Feature Code Entry.” If
enabled, it requires phone users to always press the Special button before entering a feature
code.
CAUTION
Changing a feature code may affect the accessibility of other features.
∞
SPCL