Page 6-404
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Outgoing Access
D. OUTGOING ACCESS
6.9 The next three fields control the outgoing access for calls placed by the Fax-On-
Demand application.
6.10 Outgoing Access: This is the outgoing trunk access code that the Message Notification/
Retrieval application will use to place the outgoing fax delivery call. This field is blank by
default. To determine the outgoing access trunk group, use one of the following methods:
Method A
1. Select the current Value and enter the new value in the text box.
2. Press ENTER. A screen appears showing you what is associated with the number you
entered.
3. Select OK. The new number appears in the field.
Method B
1. Right-click on the existing value. An option box appears.
2. Select Change Outgoing Access. A window appears that asks you to select the type of
device to include.
3. Select CO Trunk Group and then select Next. The list of trunk groups appears. (You
can view them in a list by selecting the List button or view details by selecting the
Details button.)
4. Highlight the appropriate trunk group and then select Finish. Your selection appears in
the Outgoing Access field.
6.11 Outgoing Access Prefix: This is the digit dialed by the Voice Processing Unit before
the outgoing access code, if needed (e.g., a forced account code). This field can include up to
18 characters. Valid characters include digits 0-9, * and #, and “P” for pause. This field is
blank by default. To enter the prefix, click on the Value and enter the address in the text box.
Then press
ENTER or click on another field to save your change.
6.12 Outgoing Access Termination: This is the digit dialed by the Voice Processing Unit to
terminate the outgoing access code, if needed. This field can include up to 18 characters. Valid
characters include digits 0-9, * and #, and “P” for pause. This field defaults to #. To enter the
termination digit, click on the Value and enter the address in the text box. Then press
ENTER
or click on another field to save your change.
E. START/STOP TIME
6.13 These fields determine the time period during which faxes will be sent to callers. If a
caller requests a fax after the Stop Time, the system will not send the fax until the Start Time.
To provide 24-hour fax service, set both fields to the same value. Both fields default to 5:00
PM. To set the time, select the current Value. Then select the hours, minutes, or AM/PM field,
and use the arrows to scroll to the desired setting. Select another field or press
ENTER to save
your change.
NOTE: With a U.S. system, the Fax-On-Demand feature uses User Group 1 and the Home
Area Code for toll restriction information. Ensure that these are programmed correctly for outgo-
ing fax delivery calls. Also ensure that the Message Notification/Retrieval application has the
appropriate trunk access.
To Next Page
Loading...
