Inter-Tel AXXESS - Redialing; Table 5-42 Redial Feature

Page 5-253
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Redialing
FEATURES
5
42. REDIALING
42.1 The Redial feature can store one telephone number in redial memory at the station
(manually dialed or speed-dialed numbers up to 32 digits). If the station user reaches a busy
number, is disconnected, or if there is no answer, the number can be redialed easily. The station
user simply lifts the handset and presses the button or enters the Redial feature code. A
trunk access code is automatically entered and the telephone number is redialed. (If redialing
while still connected to an outside call, the connection is dropped and the trunk is reseized
before the number is dialed.)
42.2 Only one telephone number can be stored in the station’s redial memory at a time. This
number can be stored in one of two ways, depending on station programming:
• Last Number Saved: The desired number is manually stored in redial memory by the
station user. Dialing other numbers does not change the stored number. It only changes
when a new number is stored.
• Last Number Dialed: The last number manually dialed or speed dialed is automati-
cally stored. It changes every time the user dials a telephone number. (This is the
default value of the Redial feature.)
42.3 The Last Number Saved and Last Number Dialed features work differently depending
on the station status when it is used, as shown in the table below. Individual station program-
ming determines the mode of the Redial feature (Last Number Dialed or Last Number Saved).
See page 6-213 in PROGRAMMING for more information. The Redial feature code (380) per-
forms the redial function (programmed under the REDIAL button).
42.4 Non-display system speed-dial numbers cannot be redialed at a display phone station.
REDIAL
Table 5-42. Redial Feature
Station Status When
Redial Feature is Used
Station Has
“Last Number Saved”
Station Has
“Last Number Dialed”
Idle station Saves the last trunk access code
and telephone number that was
dialed.
A trunk is selected using the same
trunk access code as used to place
last outside call, and the last tele-
phone number is dialed.
Intercom dial tone (on or off hook) Saves the last trunk access code
and telephone number that was
dialed.
A trunk is selected using the same
trunk access code as used to place
last outside call, and the last tele-
phone number is dialed.
On an intercom call Releases the current call, seizes a
trunk using the saved trunk access
code, and dials the saved telephone
number.
Releases the current call, seizes a
trunk using the access code used
on the last outside call, and dials
the last telephone number dialed.
After selecting a trunk but before
dialing
Redials the saved telephone num-
ber on the currently selected trunk.
(Note that the current trunk is used
instead of the saved trunk access.)
Redials the last telephone number
dialed, using the currently selected
trunk.
After selecting a trunk and dialing
one or more digits
Releases the current call, seizes a
trunk using the saved trunk access
code, and dials the saved telephone
number.
Releases the current call, reseizes
the trunk (using the access code
used on that call), and redials the
digits that were dialed.
On an incoming outside call Releases the current call, seizes a
trunk using the saved trunk access
code, and dials the saved telephone
number.
Releases the current trunk, seizes a
trunk using the same trunk access
code used on the last outgoing call,
and dials the last number dialed.