Page 5-254
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Using the Last Number Saved Feature
A. USING THE LAST NUMBER SAVED FEATURE
42.5 Use the following procedures to save and redial numbers at stations that are pro-
grammed to use the Last Number Saved feature.
42.6 To save a number on a station programmed for last number saved:
NOTE: The saved number is replaced each time you repeat this procedure.
Inter-Tel Phone: While the phone is idle or while listening to intercom dial tone, press
the
REDIAL button, or press or and enter the Redial feature code (380).
You hear a confirmation tone and the display shows LAST OUTSIDE NUMBER
SAVED.
Single-Line Set: Lift the handset and enter the Redial feature code (380). When you
hear the confirmation tone, hang up.
42.7 To redial a number (last number saved):
Phone: While on a call or after selecting a trunk, press the button, or press
or
and enter the Redial feature code (380). See the chart on the previous
page to determine which trunk is selected. The saved telephone number is dialed.
Single-Line Set: While on a call or after selecting a trunk, hookflash (press
RECALL)
and then enter the Redial feature code (380). See the chart on the previous page to
determine which trunk is selected. The saved telephone number is dialed.
B. USING THE LAST NUMBER DIALED FEATURE
42.8 Use the following procedure to redial numbers at stations that are programmed to use
the Last Number Dialed feature.
42.9 To redial a number (last number dialed):
Phone: While on or off hook, press the button, or press or
and
enter the Redial feature code (380). See the chart on the previous page to determine
which trunk is selected and which digits are dialed.
Single-Line Set: Lift the handset or hookflash (press
RECALL). Then enter the Redial
feature code (380). See the chart on the previous page to determine which trunk is
selected and which digits are dialed.
To Next Page
Loading...
