Page 6-106
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Introduction
SYSTEM PROGRAMMING
1. INTRODUCTION
1.1 When you click on System in the left side of the programming window, the following
programming areas are displayed on the window on the right:
• Cabinets (see page 6-110)
• Devices and Feature Codes (see page 6-156)
• Flags (see page 6-258)
• Hunt Group-Related Information (see page 6-263)
• IP-Related Information (see page 6-265)
• Maintenance (see page 6-268)
• Numbering Plan (see page 6-280)
• Station-Related Information (see page 6-301)
• Trunk-Related Information (see page 6-319)
• Timers and Limits (see page 6-329)
• Report Programming (see page 6-339)
• System Manager (see page 6-341)
1.2 Also shown are the following system-wide parameters (see page 6-107):
• Periodic Backup Database Save Time
• Periodic Backup Database Save Retry Attempts
• Enable Periodic Backup Database Save
• Voice Processor Enable
NOTE: As of version 8.2, the major reset parameters are located under System\Mainte-
nance\Major Reset Scheduling.
1.3 Each of these programming areas are described individually in the following pages.
To Next Page
Loading...
