Inter-Tel AXXESS - T1, T1;PRI, or E1;PRI Card Configuration and Programming

Page 6-126
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
T1, T1/PRI, or E1/PRI Card Configuration and Programming
T1, T1/PRI, or E1/PRI Card Configuration and Programming
NOTE: DB Programming will not allow the system to equip PRI unless the premium feature for
“Advanced CO Interfaces” is licensed.
3.81 The T1 cards are shown in the list. T1 and T1/E1 Cards are represented as “T1 Card”
and T1/PRI and T1/E1/PRI Cards are represented as “T1 Primary Rate Card.” E1/PRI and T1/
E1/PRI Cards are represented as “E1 Primary Rate Card.” To program a port on one of the T1
cards, double-click on that card to display its programming fields.
3.82 Card Programming includes the following fields:
• T1 or E1 Circuits (see page 6-126)
• T1/E1 Diagnostics (see page 6-127)
• Timers—PRI-equipped Cards Only (see page 6-129)
• Call Type—T1/PRI Only (see page 6-130)
• Overlap Sending—E1/PRI Only (see page 6-131)
• Description (see page 6-130)
• Framing Type—T1C and E1/PRI only (see page 6-132)
• Zero Code Suppression Scheme—T1C and E1/PRI only (see page 6-132)
• CRC Processing—E1/PRI Only (see page 6-133)
• Line Build-Out—T1C and E1/PRI only (see page 6-133)
• ISDN Switch Type—T1/PRI Only (see page 6-133)
• CO Provides Progress Tones—T1/PRI Only (see page 6-134)
• Connect on Call Proceeding—PRI-equipped Cards Only (see page 6-134)
• Operator System Access—T1/PRI Only (see page 6-134)
• Send International Toll Digits (see page 6-135)
• Retry ARS Call If Call Rejected (see page 6-135)
• Use Delayed Facility for CID Propagation Method (reserved for future use)
NOTE: System software v9.0 and later provides a networking wizard to simplify the required
programming for T1/E1 PRI networking. See page page 6-87 for more information about the
networking wizard.
T1 or E1 Circuits
3.83 The following information describes how to equip circuits.
• To equip a single port: To select the port type for a specific circuit, select the current
Port description and use the drop-down list box to scroll to the new port type. Then
press
ENTER or click on another field to save the change.