Page 5-257
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Remove from Paging
FEATURES
5
45. REMOVE FROM PAGING
45.1 A phone user can prevent the phone from receiving pages or allow it to receive pages
again using these feature codes. If the phone is assigned to more than one page zone, all zones
are removed or replaced; the user cannot toggle individual zones.
45.2 To halt or enable zone pages:
1. While on or off hook, enter the Page Receive On/Off feature code (325) to prevent the
phone from receiving pages. You hear a confirmation tone, and the display shows
PAGE RECEIVE ON (or OFF).
2. Hang up if off hook.
46. DO-NOT-DISTURB
46.1 Placing a station in do-not-disturb halts all pages, incoming intercom calls, camped-on
calls, and transferred calls to that station. Queue callbacks, recalls, and direct ring-in calls are
not blocked. Another user calling the station while it is in do-not-disturb hears a repeating sig-
nal of four fast tones and a pause (display phones show the do-not-disturb message); the user
cannot camp on, but can queue or leave a message at the station.
NOTE: Direct ring-in calls that are forwarded to a station in DND will ring the DND station per
the rules of DND.
46.2 If desired, individual stations can be prevented from using do-not-disturb by disabling
the do-not-disturb option in the database (see PROGRAMMING, page 6-211.)
46.3 If a hunt group station is in do-not-disturb, calls to the user’s hunt group do not cause
the phone to ring, but the individual trunk button will flash if all other stations in the hunt
group are busy, forwarded, have hunt group remove enabled, or are in do-not-disturb. Hunt
group announcement stations and overflow stations can use do-not-disturb to block hunt group
calls by using do-not-disturb.
46.4 Phones may be given do-not-disturb override permission. These stations, when reaching
a station in do-not-disturb, can enter the Do-Not-Disturb Override feature code (373) to place a
non-handsfree intercom call to the station. Single-line stations cannot be enabled to use the Do-
Not-Disturb Override feature.
46.5 When a station is placed in do-not-disturb, the user may select one of 20 system-stored
messages that will appear on the top line of the display (unless do-not-disturb is enabled while
the user is on a call or off hook, in which case message 1 is automatically selected). When a
station in do-not-disturb is called by a display phone user, the caller sees the selected message.
To Next Page
Loading...
