Page 3-1
Installation
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
INSTALLATION
3
Installation
CONTENTS PAGE
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5
2. New System Installation Outline . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5
3. Network Installation Considerations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-7
4. Installation Guidelines for Adding to or Upgrading a System . . . . . . . . . . . . . . . 3-8
5. Pre-Installation Checklist . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-10
A. Establish Suitable Environmental Conditions for the System . . . . . . . . . . . . . . 3-10
B. Assemble the Necessary Tools and Supplies . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-11
C. Plan Station Locations and Types of Station Instruments. . . . . . . . . . . . . . . . . . 3-13
D. Plan the ATM Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-14
E. Assemble the Optional Equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-14
6. Station Cabling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-16
A. Running Cable. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-17
B. Terminating the Cables at Station Locations. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-18
Digital Phones, Single-Line Sets, and Executone Phones . . . . . . . . . . . . . . . 3-18
Analog Phones . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-18
7. Assembling the Main Distribution Frame (MDF) Backboard . . . . . . . . . . . . . . 3-22
A. Connecting the Trunk Cables to the MDF . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-24
CO Trunks in a U.S. system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-24
CO Trunks in a European system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-25
DID Trunks (U.S. Only) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-25
Lightning Protection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-26
B. Connecting T1/E1 and Primary Rate Interface (PRI) Trunks to the MDF . . . . . 3-31
For U.S. Systems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-31
For European Systems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-34
Using the DB15 Connector in Place of the RJ48C Jack . . . . . . . . . . . . . . . . 3-36
C. Connecting Basic Rate Interface (BRI) Trunks to the MDF. . . . . . . . . . . . . . . . 3-37
Connect a Power Supply to the BRS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-37
Connect Devices to the BRS Cards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-37
D. Connecting Station Cables to the MDF. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-43
With a U.S. System. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-43
With a European System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-44
DKSC-16 Extended Loop Length Modification . . . . . . . . . . . . . . . . . . . . . . 3-44
Installing SLC-16 Power Supplies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-44
E. Station Loop Resistance Test. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-68
F. Connecting Optional Off-Premises Extensions (OPX) . . . . . . . . . . . . . . . . . . . . 3-69
G. Connecting Two T1 or E1 Cards. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-70
H. Analog Fallback System (Europe Only) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-72