Page C-17
Appendix C — CP Server
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
CP Server Security Keys (ATM Systems)
APPENDICES
NOTE: The NIC is a network communications processor card that can transfer data packets
between the CP Server PC and the System or between the CP Server PC and a LAN. For a
non-ATM system, two NICs are needed for LAN installations. The RJ45 connector on the NIC
connects to the LAN via a customer-provided standard network interface cable. For an ATM-
based system, one NIC and one ATM Adapter Card is required.
D. CP SERVER SECURITY KEYS (ATM SYSTEMS)
NOTE: PALs are not required for system versions 8.0 and later. See REPLACEMENT PARTS
for the software license part numbers.
E. SOFTWARE
This is also included on the Installation CD-ROM (part no. 827.9806).
F. FIRMWARE
827.8536 and 827.8463 are 4.X CPUX components, but will work on the CP Server.
These must be used together and cannot be mixed with 5.X chips (827.8764 and
827.8769).
Table C-5. CP Server Security Key Part Numbers
Version 8.0 Base Key 827.9775
Version 8.0 Redundancy Backup Key 827.9776
Version 7.0 Base Key 827.9777
Version 7.0 Networking Feature 827.9506
Version 7.0 Redundancy Feature 827.9648
Third PCMA Option (v7.0) 827.9504
Fourth PCMA Option (v7.0) 827.9526
25-Feature Units (v7.0) 827.9509
50-Feature Units (v7.0) 827.9510
75-Feature Units (v7.0) 827.9511
100-Feature Units (v7.0) 827.9512
125-Feature Units (v7.0) 827.9513
150-Feature Units (v7.0) 827.9514
Additional 25 Feature Units (v7.0) 827.9649
Upgrade 6.X ATM to 7.X ATM 827.9639
Table C-6. Software Part Numbers
CP Server Installation SW (U.S./U.K.) CD-ROM (Includes Man-
ual)
827.9806
CP Server CPU020 Flash Operating System SW Floppy* 827.9100
Table C-7. Firmware Part Numbers
Boot ROM for CPU-512, 256, or ATM (U25) 827.8966 or 827.9268
Memory Map PAL for CPU020 256, 512, or ATM (U41) 827.8768
Boot ROM for CPUX-Slave (U25) 827.8536* or 827.8764
Memory Map PAL for CPUX-Slave (U41) 827.8463* or 827.8769
To Next Page
Loading...
