Inter-Tel AXXESS - Additional System Equipment

Page 2-99
Specifications
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Additional System Equipment
SPECIFICATIONS
2
8. ADDITIONAL SYSTEM EQUIPMENT
8.1 The following additional system equipment is available:
• Personal Computer for On-Site or Stand-Alone/remote Programming (see below)
• Modem Connection (see page 2-100)
• MSDR/Error Message Output Device (see page 2-100)
• PC Data Port Module Connection (see page 2-100)
• CT Gateway and Transceivers (see page 2-101)
• IP and Frame Relay Devices (see page 2-102)
8.2 The following requirements are also described in this section:
• Communication Parameters (see page 2-102)
• Ferrite Beads (see page 2-103)
• Power Failure Transfer Connection (see page 2-103)
• Night Transfer Connection Requirements (see page 2-103)
• System Battery Back-Up Requirements (see page 2-104)
• Additional Information (see page 2-104)
A. PERSONAL COMPUTER FOR ON-SITE OR STAND-ALONE/REMOTE
PROGRAMMING
8.3 PC Requirements: The device used for on-site or stand-alone/remote programming
must be an IBM-compatible PC running Windows 98, Windows NT 4.0, Windows 2000, Win-
dows ME, Windows XP, or Windows Vista with the following specifications:
8.4 For environmental requirements, see page 2-89.
8.5 For remote maintenance, a modem is also needed, which is available on the CPC. To
connect the PC to the Inter-Tel system for on-site programming, see the following information.
Table 2-23. PC Requirements
Minimum Requirements Recommended Specifications
Pentium II 266 MHz or higher
microprocessor
Pentium III 500 MHz or higher
32 MB RAM 128 MB RAM or more
100 MB free disk space to install
80-100 MB to run
100 MB free disk space to install
80-100 MB to run
VGA at 640x480 or greater 256-color display at 800x600 or
greater
CD-ROM CD-ROM
Mouse Mouse