Page 6-275
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Message Print
PROGRAMMING
6
8.29 Select the output port and backup port for the message print reports, using one of the
following methods:
Method A
1. Select the current Value and enter the new value in the text box.
2. Press ENTER. A screen appears showing you what is associated with the number you
entered.
3. Select OK. The new number appears in the field.
Method B
1. Right-click on the existing port. An option box appears.
2. Select Change Port. A window appears that asks you to select the type of device to
include.
3. Select None, Remote Node, or Serial Port (local) and then select Next. The list of
ports or nodes appears. (You can view them in a list by selecting the List button or view
details by selecting the Details button.)
4. Highlight the desired port and then select Finish. Your selection appears in the appro-
priate port field.
NOTE: Do not connect a Voice Processor to a serial port that is programmed for message
print output (such as PP100, PP101, etc.). This may cause the serial port to lock up and the
Voice Processor will not be connected to the port.
8.30 Message Print Output Active: To activate the error/message reporting feature, enable
the Message Output Active flag. To enable the flag, select the current Value and then select the
check box to place a check in it. Then press
ENTER or select another field to save the change.
(To remove the check and disable the flag, select the check box again.)
8.31 Output Device Line Width: To indicate whether the output device has 64, 80 or 132
character columns, select current Value and scroll to the desired column width. Then press
ENTER or click outside the field to save the change.
8.32 Print Options: These flags determine the types of error messages to be included in the
error report. To enable a flag, select the current Value and then select the check box to place a
check in it. Then press
ENTER or select another field to save the change. (To remove the check
and disable the flag, select the check box again.) The message types are described on the pre-
ceding page.
To Next Page
