Page 6-300
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Programming Route Groups
9.89 To add dial patterns to the route group: Right-click anywhere in the right side of the
window (if there is no blank space, press
CTRL+N). An option box appears.
1. Select Add To Dial Patterns List. A blank dial pattern is added to the bottom of the list.
2. Select the new dial pattern and enter its digits in the text box. Then press ENTER or
select another field to save the change.
9.90 To move a dial pattern to another location in the list: Drag and drop the pattern to
the new position. Or, highlight the dial pattern to move and press
CTRL + the up/down arrow
to move the dial pattern up or down in the list.
9.91 To delete a dial pattern from the list: To delete one or more dial pattern from the list,
highlight them and then right-click. Select
Remove Selected Items.
NOTE: To highlight a series of items, hold down SHIFT while selecting the first and last items
you want. To highlight two or more items that are not consecutive, hold down CTRL while
selecting the desired items.
9.92 Facility Groups: For each route group, select the facility group(s) to be used to route
the calls. Facility groups must be placed in the list in the order that you want them to be
selected. To determine the facility groups that will be used by this route group, double-click on
Facility Groups. The current list of facility groups, if any, appears. You can then do the fol-
lowing:
9.93 To add facility groups to the route group: Note that this is an ordered list. Place the
facility groups in the list in the order you want them to be used.
1. To add to the bottom of the list: Do not highlight any existing entry and right-click
anywhere in the right side of the window. An option box appears.
To add to the list above an existing device: Highlight the entry below the location
where you want the new entry and then right-click. An option box appears.
2. Select Add To Facility Groups List. A window appears that asks you to select the type
of device to include.
3. Select Facility Group and then select Next. The list of available facility groups appears.
(You can view them in a list by selecting the List button or view details by selecting the
Details button.)
NOTE: To highlight a series of items, hold down SHIFT while selecting the first and last
item you want. To highlight two or more items that are not consecutive, hold down
CTRL while selecting the desired items.
4.
Highlight the facility group(s) you want to add and then select Add Items. (Note that if
you select more than one, they will be placed in the list in numerical order, not in the
order you select them. To keep the list in the proper order, you may have to add one at a
time.) When you have added all the facility groups you need, select
Finish. Your selec-
tions appear in the list.
NOTE: If you want to see the programming for a specific facility group, double-click on
its number to jump to its programming area.
9.94 To move a facility group to another location in the list: Drag and drop the facility
group to the new position. Or, highlight the facility group to move and press
CTRL + the up/
down arrow to move the facility group up or down in the list.
To Next Page
Loading...
