Page 6-330
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
System Timers and Limits
DID Disconnect Recogni-
tion
150 2-500 millisec.
(0.002-0.5 sec.)
This is the minimum amount of time the circuit must
be on hook for the system to recognize that the call
has been disconnected.
DID Inpulse-dial Inter-
digit Pause Recognition
240 2-500 millisec.
(0.002-0.5 sec.)
This is the minimum pause allowed between in-com-
ing pulse-dial signals sent from the remote circuit. It
allows the system to recognize the separation
between digits.
DID Off-hook Debounce 10 2-500 millisec.
(0.002-0.5 sec.)
This is the minimum amount of time the circuit must
be off hook before the system will recognize another
on-hook/off-hook transition.
DID On-hook Debounce 12 2-500 millisec.
(0.002-0.5 sec.)
This is the minimum amount of time the circuit must
be on hook before the system will recognize another
on-hook/off-hook transition
DID Post-Seize Delay 64 2-500 millisec.
(0.002-0.5 sec.)
This is the minimum time allowed between the recog-
nition of a seizure and the beginning of digit valida-
tion. Used only for Immediate-Dial circuits.
DID Post-Signal Delay 30 2-500 millisec.
(0.002-0.5 sec.)
This is the minimum time allowed between the end of
a handshake and the beginning of digit validation.
Used only for Wink-Start and Dial-Delay circuits.
DID Pre-Signal Delay 100 2-500 millisec.
(0.002-0.5 sec.)
This is the amount of time that must elapse between
the recognition of a trunk seizure and the handshake.
DID Ready Timeout 4000 2-65000 millisec
(0.002-65 sec.)
Used only for Wink-Start and Dial-Delay circuits. This
is the maximum time the T1 or T1/E1/PRI Card or
SLA will wait for the “Digit Register Ready” com-
mand. If the timer expires, the SLA or card will auto-
matically initiate a handshake. Used only for Wink-
Start and Dial-Delay circuits
DID Seizure Recognition 30 2-500 millisec.
(0.002-0.5 sec.)
This is the minimum amount of time the circuit must
be on hook for the system to recognize that the trunk
has been seized.
DID Signal Hold 200 2-500 millisec.
(0.002-0.5 sec.)
This is the maximum duration of a wink-start hand-
shake or the minimum duration of a dial-delay hand-
shake. Used only for Wink-Start and Dial-Delay
circuits.
DISA Invalid Extension
Failure Limit
3 0-9 This determines how many times a caller will be
allowed to enter an incorrect DISA security code with-
out being dropped. To program the failure limit, enter
the desired number in the text box. Entering 0 will
allow unlimited attempts.
DISA Security Code Fail-
ure Limit
3 0-9 This determines how many times a DISA caller will
be allowed to dial an invalid extension number before
being sent to the primary attendant. To program the
limit, enter the desired number in the text box. Enter-
ing 0 will allow unlimited attempts.
Table 6-38: System Timers (Continued)
Timer
Default
Value
Range Purpose
To Next Page
Loading...
