Page 7-10
Troubleshooting
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Circuit Card LEDs
(Continued) T1/E1
Cards (T1C, T1/PRI,
E1/PRI, or T1/E1/
PRI)
Make Busy Lit yellow to indicate that the card is in the process of “busying out”
each circuit. This occurs when someone presses the Make Busy
switch. After the circuits are busied out, this LED flashes slowly. If
flashing rapidly, the busy out process was canceled because the
Busyout Switch Timeout timer expired before the card was removed.
If this happens, the LED continues to flash until the Make Busy
switch is released or the Make Busy field is disabled (System\Cabi-
nets\<T1 Card>\T1 Diagnostics\T1 Status or System\Cabinets\<E1
Card>\E1 Diagnostics\E1 Status).
Options Card Card On-Line Lit green to show functional readiness (e.g., the card is communicat-
ing properly with the rest of the system). If unlit, check for improper
connection; if still unlit, try another card or another card slot.
Circuit Busy Lit yellow to indicate that at least one of the card's resources is busy.
Unlit when all the resources are idle.
Table 7-2. Card Light-Emitting Diode (LED) Indications (Continued)
Location LED Description
To Next Page
Loading...
