Inter-Tel AXXESS - Page 1372

Page 7-92
Troubleshooting
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Factory Default Procedure
CPLD-generated TA (DTACK) not detected, using 7 wait states for SRAM.
SRAM detected: width 16 bits, size 4194304 bytes.
Testing RAM ... successful!
Decompressing card-specific code to RAM ... successful!
(decompressing 2800668 bytes into 8773820 bytes)
Default-CPC procedure requested, please press the * button again to
confirm …
- - - - - - - - - - - -
8.40 All the LEDs light solid for 3 seconds. If the * button is not pressed again at this time it
will not default the board.
8.41 If the * button is not pressed the following message appears: “No confirmation
received, skipping default-CPC procedure ...”
8.42 If the * button is pressed, the CPU will continue with the default procedure, and the fol-
lowing message appears: “
Initiating default-CPC procedure; do not power
down the system!
”
- - - - - - - - - -
Resetting OS database ...
Programming the Ethernet address into the flash device ...
Erasing parameter block 2 ...
Programming parameter block 2 ...
Erasing parameter block 1 ...
Programming parameter block 1 ...
Ethernet address successfully programmed.
OS database reset.
Deleting SRAM (4194304 bytes) ... successful!
Erasing file-system sector ... successful!
Default-CPC procedure completed!
Resetting ...
n