Page 3-177
Installation
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Uploading IP Devices
INSTALLATION
3
While in this screen, you have the following options:
• Close: Closes the screen.
• Retry: Allows you to attempt the upload again for failed operations. To retry the
upload, highlight the IP address or hostname of the devices that did not get
upgraded and click
Retry. To attempt the upload again for all devices that did not
get upgraded, do not select any IP addresses or hostnames before clicking
Retry.
• Save Log: Saves the log information to a text file (.txt).
• Cancel: Terminates the upload operation.
10. Click Close when the upload is complete.
11. After the device accepts the file, the device indicates this change of state.
— The IPC or IPRC flashes the green Card On-Line LED and the yellow Circuit
Busy LED once per second while it erases and programs its flash memory.
— The LCD on the IP PhonePlus displays ERASING FLASH, followed by PRO-
GRAMMING CODE, and followed by DOWNLOAD COMPLETE.
— The IP SLA flashes the On-Line LED and the SL Status LED once per second
while it erases and programs its flash memory.
NOTE: Do not forget to replace the boot-sector protection jumper on the IPC to the
lower two pins once the upload completes.
CAUTION
If you click Cancel while uploading files to IP devices, the Upload Utility generates a warn-
ing message. This message indicates that the IP address for the IP devices may return to
factory default, which is the same for all IP devices. In other words, all IP devices have the
SAME IP address. If this occurs, you must either reprogram the IP address for each device
or upload the file to each device one at a time.
To Next Page
Loading...
