Page 5-216
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Exiting and Re-Entering the Conference
Exiting and Re-Entering the Conference
32.8 To exit the conference and leave the other parties connected (inside party):
32.9 Inter-Tel Phone:
During the conference, press the button and hang up. The button and a
CALL button flutters.
NOTE: If all remaining parties are outside parties and the Hold timer expires while you
are out of the conference, the conference recalls your station. The recall rings at your
station, and the button flashes at the medium rate (display shows CONFER-
ENCE RECALLING). Press the button to return to the conference. If the recall
is not answered before the Recall timer expires, it will recall the attendant.
To return to the conference: Lift the handset and/or press the button again.
32.10 Single-Line Set:
During the conference, hookflash (press
RECALL) and hang up.
NOTE: If the Hold timer expires while you are out of the conference, the parties recall
your station. When the recall rings at your station, lift the handset to answer the recall. If
the recall is not answered before the Recall timer expires, it will recall the attendant.
To return to the conference: Lift the handset and/or enter the Conference feature code
(5).
Ending the Conference and Placing All Parties on Hold
32.11 To end the conference and put all parties on hold (any inside party):
32.12 Inter-Tel Phone:
During the conference, press the button and hang up. The button and a
CALL button flutters. The parties are still connected in a conference.
To place the parties on individual hold: Press the Hold button or enter the Individual
Hold feature code (336). You can then return to each party individually by pressing the
associated CALL or button.
32.13 Single-Line Set:
During the conference, hookflash (press
RECALL) and hang up. The parties are still
connected in a conference.
To place the parties on individual hold: Lift the handset and enter the Individual Hold
feature code (336). You can then return to each party individually by entering the Indi-
vidual Hold feature code again.
To Next Page
Loading...
