Page 5-265
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Remote Forward Programming
FEATURES
5
Use speed-dial and/or redial numbers (Inter-Tel phones only): In either numeric or
alphanumeric mode, you can speed dial a number (using the speed-dial button or
feature code). In numeric mode you can press the button to enter the
stored characters. You may chain speed-dial and/or redial numbers together.
a. Hang up to complete the programming.
6. To turn off Do-Not-Disturb: Enter the Do-Not-Disturb Off feature code (371). (The
On/Off feature code cannot be used in remote programming.) The call is automatically
disconnected when the feature code is accepted. If you entered an invalid feature code,
you will hear reorder tones and can try again.
C. REMOTE FORWARD PROGRAMMING
47.10 To forward a station using the remote programming feature:
NOTE: After each entry, non-display phone users will hear a confirmation tone. Outside callers
using a DISA line will hear confirmation tone followed by DISA dial tone. Display phone users
will not hear confirmation tones but will see a prompt asking for the next entry.
1.
If calling from an outside telephone, access the system through a DISA line. Enter the
DISA security code (if applicable). You hear a confirmation tone followed by DISA
dial tone.
If programming from another station, lift the handset or press the Speaker button.
2. Enter the Remote Programming feature code (359). If you have a display, it shows
ENTER EXTENSION. Menu button phone users can press the IC DIR button to use the
intercom directory to look up a number.
3. Enter the extension to be forwarded. If you have a display, it shows ENTER PASS-
WORD. If you entered an invalid extension number, you will hear reorder tones and can
try again.
4. Enter the extension’s password, followed by #. If you have a display, it shows ENTER
FEATURE CODE.
NOTE: If you enter an incorrect password, the display will show INVALID PASSWORD
and the call is disconnected. Station users will hear reorder tones.
5.
To turn on Call Forward:
a. Enter one of the following Call Forward feature codes. If you entered an invalid
feature code, you will hear reorder tones and can try again.
Call Forward All Calls355
Call Forward If No Answer356
Call Forward If Busy 357
Call Forward If No Answer/Busy358
a. Enter the forwarding destination. This can be an extension number or a trunk
access code followed by an outside telephone number.
If the forward destination is an extension number, programming is complete, and
the call is disconnected automatically.
If the forward destination is an outside number, hang up to complete the program-
ming.
To Next Page
Loading...
