Page 5-274
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Setting System Date and Time
52.9 To turn night mode on:
1. While on hook, enter the Enable Network Night feature code (9861).
2. You are prompted to enter a node number. Enter the desired node number. (For individ-
ual nodes, enter a number between 01 and 63. For all nodes, enter 00.)
3. You hear a single confirmation tone. The display shows NIGHT MODE IS ON. Then
the display shows NODE X IS IN NIGHT MODE until day mode is turned on.
52.10 To turn day mode on:
1. While on hook, enter the Enable Network Day feature code (9862).
2. You are prompted to enter a node number. Enter the desired node number.
3. You hear a single confirmation tone. The display shows DAY MODE IS ON.
C. SETTING SYSTEM DATE AND TIME
52.11 Occasionally, the system time or date needs to be reset (for example, when the system is
defaulted or for daylight-saving time). Any Administrator can change the date and time that
appears on all display phones and in the SMDR reports. The day of the week is automatically
calculated and set by the system when the date is entered.
52.12 To set the system date and time:
NOTE: If you make a mistake, press the button to backspace or press or CANCEL
to leave it unchanged and start over.
1. While on hook, enter the Set Date/Time feature code (9800). Your display shows DATE
(current date).
If you do not need to change the date, press or
ACCEPT to skip to the TIME
XX:XX prompt.
2. Use the keypad buttons to enter the month, day, and year. For example, press 020305
for February 3, 2005. When finished, the display shows TIME (current time). If you
entered the date incorrectly, the display shows INVALID DATE and you are prompted
to enter a new date.
NOTE: If using a station programmed for Japanese, enter the date as year, month,
date. For example, 050203 for February 3, 2005.
If you do not need to change the time, press or ACCEPT twice to exit. The display
shows SYSTEM DATE AND TIME UPDATED.
3. Use the keypad buttons to enter the time in hours and minutes. (For example, enter
0900 for 9:00.) If you entered the time incorrectly, the display shows INVALID TIME
and you are prompted to enter a new time.
4. If the system is set for 12-hour display format, the display shows SELECT AM OR PM
(AM=1 PM=2). Press (or the
AM menu button) for AM or press (or the PM
menu button) for PM. The display shows SYSTEM DATE AND TIME UPDATED. If
you press any button other than 1 or 2, the display shows INVALID TIME and you are
prompted to enter a new time.
NOTE: If using a station programmed for Japanese, the prompts will be reversed, and
you will set the AM/PM before the hour and minutes.
To Next Page
Loading...
