Page 5-304
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Seizing a Device
If there is only one device on the selected port, the selected device is seized as if the
user had directly entered the extension or trunk number.
If there is more than one device on the selected port, the display shows ENTER
DEVICE. Enter the number of the device to be seized. Valid numbers depend on the
type of devices installed. (If you enter an invalid board number, the display shows
INVALID BOARD NUMBER.) When the device has been selected, it is seized as if the
user had directly entered the extension or trunk access number.
5. Enter the Diagnostics Mode feature code (9900 or 9100) to turn off diagnostics mode.
The display shows DIAGNOSTICS OFF.
52.68 For example, if the Administrator wanted to seize the T1 or E1 trunk on the tenth circuit
of the T1C or E1C in card slot 3 (circuit 3.10.0), the entries would be as follows:
ENTER BOARD: 3
ENTER PORT: 10
(Device number not required.)
However, to select the first single-line device connected to the second circuit of the KSC in
card slot 5 (circuit 5.2.1), the entries would be as follows:
ENTER BOARD: 5
ENTER PORT: 2
ENTER DEVICE: 1
To Next Page
Loading...
