Page 6-84
Programming
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Export/Import Devices
14.4 Select the following information, then select
Start. (Or select Exit to cancel the opera-
tion without exporting any information.)
• Operation: Select the desired option to determine whether you will be importing
devices into the local node or exporting local devices to a remote node.
• Remote Node Number: Select the node(s) you want to export the information to or
import the information from, by placing checks in the appropriate boxes.
• Device Type: Select the types of devices you want to export or import by checking the
appropriate boxes. You can select any combination of devices.
NOTE: If running system versions 8.1 and later, IP device information is automatically
included if you import or export all keysets. In addition, IP SLAs are automatically
included if you import or export all single-line sets.
14.5 When you select Start to begin the export or import operation, the lower box in the
screen shows the status of the export or import.
14.6 If you are exporting information, the node you are exporting from is listed as “Node X:
Export Source.” The destination node or nodes will show the node number and the current sta-
tus of the export. After the import from a node is completed, either successfully or unsuccess-
fully, the import source node displays the final status of the import. The screen will show
messages as explained in the chart below.
14.7 After completing an import operation, you must terminate DB Programming to update
the database.
14.8 If the local node cannot communicate with the remote node, the export or import will
fail. Before you attempt to export or import information, verify that you can reach the remote
node by dialing the extension assigned to the remote node. If you hear dial tone, you should be
able to successfully export or import information. If you receive a “NOT REACHABLE” mes-
sage, you must determine why calls are not properly being routed to the specified remote node
before you can export or import information. If you camp on to a node while trying to reach
the remote node, wait for the node trunk group to become available so that you can guarantee
the remote node can be reached.
Table 6-15: Remote Node Connection Status
Status Meaning
Starting Up Indicates that the node is attempting to initiate the export.
Creation XX% This node is XX percent done with the creation portion of the
export.
Deletion XX% This node is XX percent done with the deletion portion of the
export.
COMPLETED This node successfully completed the export.
Waiting... When importing, this status indicates that this node is waiting for
another node to finish before it can become an import source
Error - Not Reachable The export to the node failed because the export source node
could not communicate with this node.
Error - KTS Programming The export to the node failed because someone on the node
was performing Keyset Programming.
Error - Voice Processor The export to the node failed because the link to the Voice Pro-
cessor is down.
Error - DB Programming The export to the node failed because someone on the node
was performing DB Programming.
To Next Page
Loading...
