EasyManua.ls Logo

Cisco ONS 15454 Series - Page 33

Cisco ONS 15454 Series
850 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Procedures
xxxiii
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
NTP-A297 Change Card Service State 11-6
NTP-A220 Upgrade the XCVT Card to the XC10G Card 12-2
NTP-A296 Upgrade the TCC2 Card to the TCC2P Card 12-3
NTP-A93 Upgrade the DS3-12 Card to the DS3-12E Card 12-5
NTP-A308 Upgrade In-Service Low-Density Electrical Cards to High-Density Electrical Cards 12-7
NTP-A254 Downgrade a DS3-12E/DS3NE Card to a DS3-12/DS3N-12 Card 12-10
NTP-A153 Upgrade the AIC Card to AIC-I 12-12
NTP-A94 Upgrade OC-N Cards and Spans Automatically 12-12
NTP-A95 Upgrade OC-N Spans Manually 12-15
NTP-A309 Convert a 1+1 Point-to-Point to a Linear ADM Automatically 13-2
NTP-A154 Convert a 1+1 Point-to-Point to a Linear ADM Manually 13-5
NTP-A303 Convert an Unprotected Point-to-Point or 1+1 Linear ADM to a Two-Fiber BLSR Automatically 13-6
NTP-A155 Convert a 1+1 Point-to-Point or a Linear ADM to a Two-Fiber BLSR Manually 13-8
NTP-A299 Convert a Point-to-Point or Linear ADM to a Path Protection Automatically 13-11
NTP-A156 Convert a Point-to-Point or Linear ADM to a Path Protection Manually 13-12
NTP-A267 Convert a Path Protection to a Two-Fiber BLSR Automatically 13-13
NTP-A210 Convert a Path Protection to a Two-Fiber BLSR Manually 13-15
NTP-A211 Convert a Two-Fiber BLSR to a Four-Fiber BLSR Automatically 13-17
NTP-A159 Modify a BLSR 13-18
NTP-A212 Add a BLSR Node 14-2
NTP-A240 Remove a BLSR Node 14-6
NTP-A105 Add a Path Protection Node 14-9
NTP-A294 Remove a Path Protection Node 14-11
NTP-A262 Add a Node to a Linear ADM 14-13
NTP-A312 Add a Node to a Linear ADM Using the Wizard 14-14
NTP-A313 Remove an In-Service Node from a Linear ADM 14-17
NTP-A107 Inspect, Clean, and Replace the Air Filter 15-2
NTP-A108 Back Up the Database 15-4
NTP-A109 Restore the Database 15-5
NTP-A163 Restore the Node to Factory Configuration 15-8
NTP-A300 Viewing the Audit Trail Records 15-9
NTP-A214 Off-Load the Audit Trail Record 15-11
NTP-A306 Off-Load the Diagnostics File 15-12
NTP-A302 Initiate or Clear an External Switching Command 15-12
NTP-A112 Clean Fiber Connectors 15-13

Table of Contents

Other manuals for Cisco ONS 15454 Series

Related product manuals