Page D-4
Appendix D — CPC64/CPU64 Configuration
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Pre-Programmed Features
Pre-Programmed Features
1.7 All of the default databases have the following pre-programmed features:
• Directories premium feature is licensed
• Serial ports set to 38400
• Allow Green LEDs flag enabled
• Three-digit extensions (unless networking, then use four digits)
• One hunt group with all telephones except 100 (or 1000)
• DSPs on the OPC are programmed to support Caller ID (U.S. version only)
1.8 Databases with Voice Mail have:
• Mailboxes have been created for each of the stations.
• Unassociated mailbox 500 (or 5000) is the Administrator
• Voice Processing applications have been created for Voice Mail, Message Retrieval/
Notification, Automated Attendant, and Auto Attendant Recall
• The Voice Mail application is extension 250 (or 2500)
• System Forwarding to voice mail is programmed for each station (except 100/1000) for
outside calls, during day mode, using no answer and DND conditions
• Voice Mail is the Message Center for all stations
• Transfer prompts are disabled
• During day mode, calls ring 100/1000 (no system forwarding on this station).
• During night mode, calls ring to the automated attendant and recall to the auto attendant
recall application
• In each keymap, the last button (8th or 12th) is programmed as a “Voice Mail” (250/
2500) button to simplify transfers and access to voice mail
1.9 Individual Line Key Databases have:
• Hold button programmed as System Hold
• Eight buttons are programmed as individual trunks
• An Alternate Keymap is programmed with trunks 9-16
• A button is programmed to switch keymaps
1.10 The Networked Node has the following programmed:
• The T1/E1/PRI card is set for Private Networking and all 23 B-channels are activated
NOTE: A Network Clock Card (NCC) is required.
• Advanced CO Interfaces premium feature is licensed
To Next Page
Loading...
