Page D-26
Appendix D — CPC64/CPU64 Configuration
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
EVMC Voice Processing Save and Restore
E. EVMC VOICE PROCESSING SAVE AND RESTORE
4.21 To perform a Voice Processing save or restore operation on the EVMC you will need:
• An external floppy drive (available in the Floppy Drive Kit 828.1486)
• Zip Drive Backup Kit (part number 828.1460) and blank, formatted Zip Disks (The
number required depends on the size of the Voice Processing database. Check the Voice
Processing
Total Storage Used statistics in DB Programming.)
• A keyboard and monitor
NOTE: The Zip Drive is supported only in software versions later than 5.270.
4.22 Use the following procedure to install the Voice Processing applications software via
floppy drive:
1. Shut down the EVMC by using a small object to press the Power Down button on the
front edge of the card (see illustration on page D-22 for its location). The EVMC will
go through a shutdown process and the “OK To Remove Card” LED will flash. When
shutdown is complete, the LED will be solidly lit.
NOTE: When the “OK To Remove Card” LED turns green, it is safe to remove the
EVMC from the equipment chassis for the next 10 seconds. If you do not remove the
card within that amount of time, allow the card to reboot and wait for the “Card On-Line”
LED to light. Then you can repeat the shutdown process and remove the EVMC.
2.
Remove the EVMC from the equipment chassis and lay it on a clean, flat, anti-static
surface.
3. Attach the floppy drive cable to the floppy connector on the EVMC (see Figure D-3 on
page D-22 for location).
NOTE: When plugging in the floppy drive or power connector ribbon cable, the red
stripe goes on the side closest to the power supply.
4.
Attach the larger connector on the floppy drive power cable to the floppy drive.
5. Attach the other (smaller) connector on the floppy drive power cable to the floppy drive
power connector on the EVMC.
6. Temporarily install the EVMC in slot 6 of the equipment chassis (Or any slot that has a
vacant space to the right, to allow room for the floppy ribbon cable. The slot you
choose does not need to be programmed for an EVMC for this to work properly.)
CAUTION
If the EVMC is not shut down properly before it is removed from the equipment chassis, the
database will probably become corrupted, and the EVMC will go into an endless rebooting
cycle.
CAUTION
When handling the EVMC be very careful not to damage the hard drive. It is sensitive
to vibration, pressure, and shock.
To Next Page
Loading...
