Installation
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Page
3-186
Wall Mounting Model 8500, 8520, and 8560 Phones
13.12 To wall mount the Model 8000 digital phones that have a support mechanism:
NOTE: The following instructions apply to phones that have a support mechanism (see illustra-
tion below) that fits into holes in the base.
1. Collapse the support mechanism completely and secure it against the bottom housing of
the phone, as shown below.
2. Close the base completely so that it lies flat against the phone. (The two rivet holes on
the base align with the two rivet holes on the bottom housing of the phone.)
3. Plug the four-inch line cord into the jack on the back of the phone and thread the line
cord through the wall-mount knockout on the base.
4. Insert the two plastic rivets through the base and press them firmly into the holes on the
bottom housing of the phone. This locks the base to the phone.
5. Test the base to verify that it is securely locked to the phone.
6. Re-attach the metal plate to the phone base.
7. Plug the line cord into the jack on the wall-mount bracket and position the phone
securely on the wall-mount bracket.
8. Flip the handset hanger down to the horizontal position and lock it into place. This
holds the handset in place.
Bottom Housing
Support
(Base not shown)
Mechanism
Base
Rivet Holes
Rivet Holes
To Next Page
Loading...
