Page 5-19
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Station Feature Codes
FEATURES
5
Program Bit Rate 393 (Executive Display, Professional Display, Standard Dis-
play, Associate Display, Model 8520, and Model 8560
Phones Only) Allows an Executive Display, Professional
Display, Standard Display, Associate Display, Model
8520, or Model 8560 Phone user to change the bit per
second (bps) rate of an attached PCDPM’s serial port.
Program Keys 397 (Inter-Tel Phones Only) User-programmable feature but-
tons and station speed-dial buttons can be programmed
using this feature code.
Program Station Password 392 Programs the Station password for the Remote Program-
ming feature. The password can be changed by entering
the Program Station Password feature code at the station
or when using the Remote Programming feature.
Queue Request 6 Requests (or cancels) an automatic callback when a
busy trunk or station becomes available. (Analog phones
have a default QUEUE button.)
Record-A-Call 385 If the system is programmed with a Record-A-Call appli-
cation, the stations can be programmed to use the
Record-A-Call feature. It allows users to enter a feature
code whenever they want to record an ongoing call in
their designated Record-A-Call mailbox. Users can
retrieve the recorded messages later, just as they would
any other mailbox messages.
Redial 380 Redials the last outside telephone number dialed or
saved at the station (up to 48 digits). Also used to save
numbers at phones programmed for last number saved.
(Inter-Tel phones use the REDIAL button).
Redirect Call 331 Allows the phone user to route ringing outside, intercom,
and camped on calls to another station, hunt group, out-
side number, voice mail, or Do-Not-Disturb.
Reminder Message
Reminder Message Cancel
305
306
(Inter-Tel Phones Only) Sets reminder messages that
signal the station at specific times. Or, cancels all
reminder messages for the station.
Remote Programming 359 Allows a user to place a phone in do-not-disturb mode or
forward the station’s calls, either from another station or
through DISA.
Reverse Transfer (Call Pick-Up) 4 Picks up a call ringing or holding at a station or hunt
group
Review Keys 396 (Inter-Tel Phones Only) User-programmable feature but-
tons and station speed-dial buttons can be viewed using
this feature code.
Ring Intercom Always On/Off 377 Enables/disables the feature that allows the station to
always place private (non-handsfree) intercom calls.
Ring Tone Selection 398 (Inter-Tel Phones Only) Selects the type of ringing alert
tone that is heard from the phone.
Table 5-2. Station Feature Codes (Continued)
Feature Name
U.S. [Europe]
Code
Definition
To Next Page
Loading...
