Page 5-18
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Station Feature Codes
Hold – Individual 336 Places a call on hold so that it can be picked up directly
at that station or through a reverse transfer from any
other station. (Inter-Tel phones use the HOLD button.)
Hold – System 335 Places an outside call on system hold. It can be picked
up directly at any phone that has an individual trunk but-
ton and has allowed-answer and/or outgoing access for
that trunk or by the station that placed it on hold. (If used
on conference or intercom calls, the system places the
call on individual hold.)
Hunt Group Remove
Hunt Group Replace
Hunt Group Remove/Replace
322
323
324
Removes the station from its assigned hunt group(s) or
places it in again. Does not affect non-hunt group calls.
The remove/replace feature code can be used to toggle
the feature.
LCD Contrast Adjustment 303 (Models 8662, 8622, 8620, 8660, and 8560 Phones
Only) Adjusts the LCD contrast on the display. The
phone must be idle to use this feature.
Message 365 This feature code is used for leaving and retrieving a
message waiting indication at a called station or the
called station’s message center. Depending on how the
message was left, the called station user either retrieves
the message from his/her message center or from the
station that left the message. (Inter-Tel phones use the
MSG button.)
Message – Cancel 366 Allows the station user to cancel a message waiting indi-
cation that the user left at another station.
Message – Cancel Current 368 Cancels a message waiting indication that is waiting at
the station without requiring the user to respond to it.
(Phones can use the asterisk [*] button while viewing the
message.)
Message – Silent 367 Leaves a message waiting indication at a station without
first placing an intercom call. (This is the code that
should be used by analog voice mail units connected to
the phone system.)
Mute On/Off 314 (Inter-Tel Phones Only) Turns the microphone on or off
during a call. If muted, the phone user can hear the other
party, but the party cannot hear the phone user. (Phones
can also use the MUTE button.)
Page 7 When followed by a paging zone code (0-9 or 0-49), it
allows announcements to be made through phone
speakers and any external paging speakers in the page
zone. (Analog phones have a default PAGE button.)
Page On/Off 325 (Inter-Tel Phones Only) Halts pages through the phone
speaker or allows them to be received again.
Table 5-2. Station Feature Codes (Continued)
Feature Name
U.S. [Europe]
Code
Definition
To Next Page
Loading...
