Page 5-191
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Off-Hook Voice Announce (OHVA)
FEATURES
5
25.7 To place an off-hook voice announce call:
1. When placing an intercom
call to a busy OHVA-enabled
phone, do not hang up. You
hear busy signals until the
Camp-On and OHVA Screen-
ing timers expire. (If you hear
music after the Camp-On
timer expires, conditions for
an OHVA call were not met,
and you are camped-on. See
page 5-177.)
2. When the OHVA Screening timer expires (and if the phone’s secondary voice path is
available), you are automatically connected to the called party’s speakerphone.
25.8 To place an immediate off-hook voice announce call (phones with DSS/BLF but-
tons only):
NOTE: This method can only be used if the database has been programmed to allow phones
with DSS/BLF buttons to bypass the Camp-On and OHVA Screening timers. See page 6-212 in
PROGRAMMING.
1.
When an intercom call is placed using the DSS/BLF button to a busy OHVA-enabled
phone, do not hang up.
2. Press the DSS/BLF button for that phone again. If the phone’s secondary voice path is
available, you are immediately connected and may speak.
25.9 To receive an off-hook voice announce call (OHVA-enabled phones only):
1. While on a call using the handset, you hear a camp-on tone. The display shows CALL
ANNOUNCE FROM (username). Do nothing. When the OHVA Screening timer
expires, you hear a double tone. You are connected with the intercom caller via the
speakerphone. Your original call remains connected on the handset.
NOTE: If you press while speaking to the caller on the speakerphone, the
handset microphone will be muted and the caller on the handset will not hear you or the
OHVA caller. Press again to enable the handset.
2.
To terminate the OHVA call: Press the lit Speaker button or have the OHVA caller
hang up. If you terminate the original call by hanging up the handset, you remain con-
nected to the OHVA call in the handsfree intercom mode.
25.10 To block an off-hook voice announce call (OHVA-enabled phones only):
1. While on a call using the handset, you hear a camp-on tone. The displays CALL
ANNOUNCE FROM (username). To cause the intercom call to camp on, press the
Speaker button. The button flashes.
2. If you want to send do-not-disturb signals to the camped-on call, press the but-
ton.
OFF-HOOK VOICE ANNOUNCE
PHONE WITH
PCDPM
Ext. 1103
Ext. 1002
ACTIVE
CALL ON
HANDSET
Caller places a call
to ext. 1002 and
hears busy signal
Display shows INTERCOM
CALL FROM 1103
After 5 seconds, call is
established on speaker, if not
blocked.
1
2
3
To Next Page
Loading...
