Page 2-5
Specifications
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Introduction
SPECIFICATIONS
2
1.5 In addition, a wide variety of “analog” station instruments can be used on the Inter-Tel
phone system, including:
• IMX 24-Line AIM Phones (display only)
• IMX 12-Line AIM Phones (display only)
• IMX 8-Line Dual-Circuit AIM Phones (display only)
• IMX 24-Line Phones (standard and display)
• IMX 12-Line Phones (standard and display)
• IMX 8-Line Phones (non-display only)
• Inter-Tel/DVK 24-Line Phones (standard and display)
• Inter-Tel/DVK 12-Line Phones (standard and display)
• Inter-Tel/DVK 8-Line Phones (standard and display)
• GMX 24-Line Phones (standard and display)
• GMX 12-Line Phones (non-display only)
• Executone
®
Model 160, 64, 32, 18, and 12 Phones
• Executone Agent Terminal
• Executone 6-, 17-, and 29-Key Wave Phones
• 48-Key DSS Consoles (for use on Executone phones only)
• Industry-standard single-line, dual-tone multi-frequency (DTMF) or pulse-tone sets
(v2.x or later software is required for pulse-tone sets)
NOTE: The volume adjustment range of non-AIM and non-DVK analog phones may
not be suitable in all user environments. In such cases, Inter-Tel recommends using
AIM and/or DVK phones, if possible.
ALSO: The Executone Model 160, 64, 32, 18, and 12 Phones, Agent Terminal, 6-, 17-,
and 29-Key Wave Phones, and 48-Key DSS Consoles are supported by U.S. software
only.
1.6 The phone system also supports the following IP devices:
• Axxess IP PhonePlus
• Eclipse IP PhonePlus
NOTE: The v8.1 and 9.0.0 firmware IPRC does not support IP SoftPhone.
• IP SoftPhone (requires a v1.x firmware device IPRC)
• Models 8600, 8620/8622, 8662, and 8690 multi-protocol endpoints (support both SIP
and ITP)
• IP single-line adapters (IP SLAs)
1.7 See the latest IP Devices Installation Manual (document part no. 835.2195) for details.
1.8 You can also use the following devices with versions 8.1 and later software:
To Next Page
Loading...
