Page 5-235
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Viewing System Speed-Dial Numbers
FEATURES
5
38.9 The system speed-dial numbers and names are stored in battery-backed RAM and will
not be erased in the event of a power failure.
38.10 The system speed-dial numbers and names are programmed by the installer or at any
Administrator station. (See page 5-297 for Administrator programming instructions.)
Viewing System Speed-Dial Numbers
38.11 To view system speed-dial numbers and names:
NOTE: If you make a mistake, use the button to backspace.
1. While on hook, press or enter the System-Speed Dial feature code (381). The
display shows REVIEW SYS SPEED # (0000-4999).
2. Enter the desired location code (0000-4999) or press the SEARCH menu button. The
display shows the programmed name and number.
3. If desired, scroll forward through the speed-dial locations in alphabetical order by press-
ing the high end of the
VOLUME button or the NEXT button, or scroll backward by
pressing the low end of the
VOLUME button or the PREVIOUS button.
4. Repeat steps 2 and 3 for each speed-dial location to be viewed. Or, press or CAN-
CEL to terminate this feature.
5. To automatically select a trunk and dial the displayed number, press .
Dialing System Speed-Dial Numbers
38.12 To dial system speed-dial numbers at a phone:
1. If desired, lift the handset and select an outgoing trunk. (You may skip this step.)
2. Press or enter the System Speed-Dial feature code (381). The display shows
REVIEW SYS SPEED # (0000-4999). Non-display phone users hear a confirmation
tone.
3. Enter the location code (0000-4999) for the desired number. If you have not selected a
trunk, press or the
ACCEPT menu button to accept the number and automatically
select a trunk. Or, press the ARS button, a trunk button, a trunk group button, or the
button to select a trunk. The number is automatically dialed. (Display
phones show the number dialed unless it is a non-display number.) If you hear reorder
tones, your station is restricted from dialing the selected number. If the display shows
INVALID BIN NUMBER, you entered an invalid speed-dial location code.
38.13 To dial system speed-dial numbers at a single-line set:
1. Lift the handset and select an outgoing trunk.
2. Hookflash (press RECALL) and enter the System Speed-Dial feature code (381). You
hear a confirmation tone.
3. Enter the location code (0000-4999) for the desired number. The number is automati-
cally dialed. If you hear reorder tones, your station is restricted from dialing the
selected number.
To Next Page
Loading...
