Page 5-238
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Programming Station Speed-Dial Numbers and Names
3. When the display shows ENTER NUMBER, do one of the following:
• To enter or change a number: Dial the extension number or telephone number
(up to 16 digits, including pauses and hookflashes/recalls) to be stored. To in clude
*, #, a hookflash/recall, or a pause in the number, press or
once
for an asterisk (*), twice for a pound [hash] (#), three times for a hookflash
(recall), or four times for a pause. You can enter more than one *, #, or hookflash
(recall) in a row by pressing the button to move to the next character (not
necessary after pauses). If you make a mistake, press to back up and erase,
or press or
CANCEL to leave the number unchanged; then start over at step 1.
• To erase an existing number and leave it blank: Press until the number
is erased.
4. Press to exit. Repeat these steps for each additional number to be stored.
38.22 To program station speed-dial numbers at a non-display phone:
NOTE: If you make a mistake, press or CANCEL; then start over. The number in memory
remains unchanged. Or, use the MUTE button to backspace.
1.
While on hook, enter the Program Station Speed Dial feature code (383).
2. Press the speed-dial button to be programmed or dial the desired speed-dial location
code (0-9). If you hear reorder tones, you entered an invalid speed dial location code;
try again.
3. Do one of the following:
To enter or change a number: Dial the extension number or telephone number
(up to 16 digits, including pauses and hookflashes/recalls) to be stored. To in clude
*, #, a hookflash (recall), or a pause in the number, press or
once
for an asterisk (*), twice for a pound [hash] (#), three times for a hookflash
(recall), or four times for a pause. You can enter more than one *, #, or hookflash
(recall) in a row by pressing the button to move to the next character (not
necessary after pauses). If you make a mistake, press to back up and erase,
or press or
CANCEL to leave the number unchanged; then start over at step 1.
To erase an existing number and leave it blank: press until the number
is erased.
4. Press to exit. Repeat these steps for each additional number to be stored.
38.23 To program station speed-dial numbers at a single-line set:
NOTE: If you make a mistake, press ; then start over. The number in memory remains
unchanged.
1. Lift the handset and enter the Program Station Speed-Dial feature code (383). You hear
a confirmation tone.
2. Dial the desired speed-dial location code (0-9). If you hear reorder tones, you entered
an invalid speed dial location code; try again.
To Next Page
Loading...
