Page 5-239
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
Viewing Station Speed-Dial Numbers
FEATURES
5
3. Do one of the following:
To enter or change a number: Dial the extension number or telephone number
(up to 16 digits, including pauses and hookflashes/recalls) to be stored. To include
*, #, a hookflash (recall), or a pause in the number, hookflash (recall) once for an
asterisk (*), twice for a pound [hash] (#), three times for a hookflash (recall), or
four times for a pause. If you make a mistake, press to leave the number
unchanged; then start over at step 1.
To erase an existing number and leave it blank: Overwrite the existing number
by entering only a hookflash (recall) as the new number.
4. Hang up to exit. Repeat these steps for each additional number to be stored.
Viewing Station Speed-Dial Numbers
38.24 To view the contents of a speed-dial button (on a display phone):
1. While on hook, enter the Review Keys feature code (396). The display shows PRESS
THE KEY TO REVIEW. Press the desired speed-dial button. The display shows the
currently stored number and name.
2. After viewing the number, press the Speaker button, , or to exit, or wait for the
display to return to date and time.
38.25 To view the stored numbers and names (on a display phone):
1. While on hook, enter the Program Station Speed Dial feature code (383). The display
shows PROGRAM STN SPD # (0-9) OR SCROLL. Do one of the following:
• Use a Location Code: Dial the desired speed-dial location code (0-9). When the
name appeared, press or
ACCEPT to view the number.
• Scroll through the Displayed Numbers: Scroll to the desired number by pressing
the
VOLUME, NEXT, or PREVIOUS button. The name and number are displayed
for each location.
• Use the Menu Buttons: Use the menu buttons to select the desired speed-dial
location. When the name appeared, press or
ACCEPT to view the number.
2. After viewing the number, press the Speaker button, , or to exit, or wait for the
display to return to date and time.
Dialing Station Speed-Dial Numbers
38.26 To dial a station speed-dial number at a single-line set:
1. Lift the handset. (Phones can remain on hook.)
2. If placing an outside call, select an outgoing trunk or use ARS.
If placing an intercom call or if the outside number contains a trunk access code, skip
this step.
3. Hookflash (press RECALL) and enter the Station Speed-Dial feature code (382). You
hear a confirmation tone. Then dial the location code (0-9). The number is dialed.
To Next Page
Loading...
