Page 5-287
System Features
INTER-TEL
®
AXXESS
®
MANUAL VERSION 11.0 – May 2008
System Programming Using an Administrator's Station
FEATURES
5
NOTE: If the feature times out while entering an extension number, the dis-
play shows INCOMPLETE EXTENSION.
2.)
The display shows SWAP (extension) WITH EXTENSION. Enter the second
extension number to be swapped using the same methods previously
described. The display shows DATABASE UPDATED.
NOTE: If you cancel or terminate the feature without entering the second
extension number, the system discards any changes that have not yet been
saved, and the display shows NO UPDATE PERFORMED. If the entered
extension is the administrator station performing the swap, the same exten-
sion number as the target station, or the wrong device type, the display shows
CONFLICTING EXTENSION.
5.
When the display shows ENTER SYSTEM OPTION, press again to exit to the
ENTER DATABASE OPTION prompt.
6. When finished with all programming, press while the ENTER DATABASE
OPTION prompt is displayed. This ends the programming session.
7. If a system reset is required, the display shows ENTER SYS RESET OPTION. Do one
of the following:
— Delayed Reset: Press or the
DELAYED menu button to delay the reset. The dis-
play shows DELAYED RESET SCHEDULED. The system will be reset at the
pre-programmed time (see page 6-271).
— Immediate Reset: Press or the
IMMEDIATE menu button to reset the system
now.
NOTE: A system reset will drop all calls in progress.
To Next Page
Loading...
